This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Text excerpt from page 1 (click to view)
HOB 475/S
eq
NL
F
PRODUCT DESCRIPTION SHEET
q wq
1. Removable panstand grids 2-3. Medium burners 4. Large burner 5. Small burner 6. 7. 8. 9. 10. Double crown burner Medium burner control knob Medium burner control knob Double crown control knob Large burner control knob
u i o p Q W
v t i u s
11. Small burner control knob 12. Electric ignition button
>
Symbols
r
z
t
Shaded circle x Tap closed Large Maximum opening/ flame delivery
}
}
Small flame
Minimum opening or reduced delivery
Operation of burners with safety device and electric ignition
To light one of the burners: x Press the relative knob and turn it anticlockwise to the large flame setting .
}
x
x
At the same time, press the button with the star >. The spark plug gives out a spark that causes the burner to ignite. Once the burner is lit, keep the knob pressed for about 10 seconds.
Release the knob. If the burner does not ignite, repeat the operations described above.
x
Note: � Should particular local conditions of the delivered gas make the ignition of the burner difficult, it is advisable to repeat the operation with the knob turned to the small flame setting . � The burner safety system serves to prevent the emission of gas if the flame should be extinguished accidentally (draughts, interruptions in gas supply, dousing with liquids, etc). � The separator panel, positioned beneath the cooktop at a minimum distance of 20 mm, must be sealed. � For Belgium: replace the gas fitting with the one supplied (this job must be done by a qualified technician).
}
USING THE DOUBLE-RING BURNER
When using the double-ring burner, leave the knob on the maximum setting (large flame ) for at least five minutes after lighting before selecting a lower setting.
