|
|
|
Who's Online
There currently are 5464 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
6. Manual recording
General information
Use 'Manual Recording' to make a spontaneous recording (for example, a programme currently being shown). If you want to start and stop a recording manually, read the section 'Recording without automatic switch-off'. If you want to start a recording manually but have it stopped automatically, read the section 'Recording with automatic switch-off'. (e.g. not to record to the end of the tape) Read the section 'Automatic recording from a satellite receiver', if you want a recording to be controlled automatically by a satellite receiver.
Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette. 1. 2.Use P+ P- or 2.
0..9 to select the programme number you want to record.
3.Press RECORD/OTR I . 3. 4.Each time you press RECORD/OTR I you will 4.
add 30 minutes to the recording time.
Preventing accidental erasing of cassettes
All cassettes (except for rental and pre-recorded purchased cassettes) have a security tab on the back of the cassette. To prevent recording over important recordings (erasing), you can remove this security tab. If you later decide to record on a protected cassette, simply cover the hole with adhesive tape.
Recording without automatic switch-off
1.Insert a cassette. 1. 2.Use P+ P- or 2.
to select the programme number you want to record, for example, 'P01'. 3.To start recording, press RECORD/OTR I . 3. 4.To stop recording, press L C . 4.
0..9
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows: 1.Find the tape position of the old recording 1. where you want to insert the new recording. 2.Look at the last minute of the old recording 2. (playback). 3.Press STILL 2 at the tape position where 3. the new recording is to go and press RECORD/OTR I . 4.Now start recording as usual by pressing 4. RECORD/OTR I on the remote control. 5.Stop recording with L C . 5.
EN
12
|
|
|
> |
|
