|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
;
The best diagram that I used in a long time. Everything was right on te money. It was easy and fast. Iwoiuld but again when I need a service manual.
Manually adding and deleting channels in the channel memory
After you have programmed the channels automatically, you can manually add or delete individual channels in the channel memory. To add or delete channels in the channel memory: To add a channel to the channel memory: Highlight the unchecked box next to the channel number you want to add, and then press ENTER to check the box. To remove a channel from the channel memory: Highlight the checked box next to the channel number you want to remove, and then press ENTER to uncheck the box. To save your new settings: Highlight SAVE and press ENTER. To revert to your original settings: Highlight CANCEL and press ENTER before saving. To remove all channels from the channel memory: Highlight CLEAR ALL and press ENTER, and then highlight SAVE and press ENTER. Note: This action cannot be cancelled unless you highlight CANCEL and press ENTER before saving your changes.
1 2 3
SPECIFIC INFORMATIONS GENERAL ADJUSTMENTS
Press MENU and open the SETUP menu. Highlight INSTALLATION and press ENTER. (A new set of INSTALLATION menu icons will appear on screen, as shown in step 3). Open the TERRESTRIAL menu, highlight CHANNEL ADD/ DELETE, and then press ENTER. The illustration below shows channels programmed for the ANT 1 antenna input. To view the list of channels programmed for the ANT 2 antenna input, highlight CHANGE ANTENNA and press ENTER.
4
� 22 �
|
|
|
> |
|
