Very easy to get, fast delivery. Was very helpful to solve my problem.
Text excerpt from page 16 (click to view)
2-2
CHAPTER 2: INSTALLING THE SYSTEM
Table 2-1 Switch 2200 Hardware Kit Qty Item 4 Rubber feet (self-adhesive) Mounting brackets M4 x 8 �athead screws �G� clips 10/32 x 1/2 Phillips screws Strain relief, AC power cord 1 M4 x 8 panhead screw To use in... Stacking the system on a table or in a free-standing stack only Installing the system in a distribution rack Installing the distribution rack brackets Installing the system in a distribution rack Installing the system in a distribution rack Relieving strain on AC power cord Installing AC power cord strain relief 6 5
Place the system near an easily accessible power outlet. You can only power down the system by removing the power cord from the power source. If you are installing the system into a free-standing stack, place the system on top of another, ensuring that the rubber feet of the upper unit �t securely in the recesses in the top of the lower unit. See Figure 2-1. Do not not to block the air intake and fan exhaust vents. CAUTION: For safety, stack no more than eight SuperStack� II components in a single free-standing stack. You are now ready to cable your system. For instructions, see Chapter 3: Cabling.
Place the feet of one system into the mounting recesses of the system below it.
2 6 4 4 1
Installing the Switch 2200 System on a Table Top or in a Free-Standing Stack
1X DAS 2X 3X 4X 5X 6X
SuperStack II Switch 2200
SUPER STACK
To install the Switch 2200 system on a table top or in a free-standing stack, follow these instructions:
1 2 3
A
B
13X
14X
15X
16X
Console
1 A B 7
STATUS Green = Link OK Red = Error
2 8 3 9 4 5 6
Run Power
10 11 12 13 14 15 16
7X
8X
9X
10X
11X
12X
FDDI
ETHERNET
Diag Over Temp
Turn the system on its side.
1X 2X 3X 4X 5X 6X
SuperStack II Switch 2200
SUPER STACK
Remove the protective covering from the rubber feet.
A
DAS B 13X 14X 15X 16X Console
1 A B 7
STATUS Green = Link OK Red = Error
2 8 3 9 4 5 6
Run Power
10 11 12 13 14 15 16
7X
8X
9X
10X
11X
12X
FDDI
ETHERNET
Diag Over Temp
Place a rubber foot onto the base of the system in each of the marked areas at the four corners of the unit.
A
