The users guide was excellent. It provided the information neeeded to connect and control the Crate system. Nothing was left to chance
Text excerpt from page 78 (click to view)
867B/863
Users Manual
Using Single Shot and Glitch Capture Softkeys
Arm < > Exit
1 (Arm) resets the trigger circuit and readies the GMM test tool to capture another single shot waveform or glitch capture transient. �Arm� is selected (highlighted) initially. When the entire waveform is captured, �Arm� reverts to normal contrast. The display shows elapsed time (hh:mm) since arming or, if a trigger subsequently occurred, time between arm and trigger. The time cycles from 00:00 through 99:59 continuously until a trigger is received.
2 and 3 (< and >) move the waveform left or right for viewing (available once the waveform is completely captured). If you press 1 again, the arm cycle starts over, < and > disappear, and the arm-to-trigger time begins at 00:00. Waveform position accomplished with < and > is retained across arm cycles. Six time base divisions prior to the trigger and 19 time base divisions after the trigger can be viewed using < and >, respectively. Refer to Figure 5-4 for an overview of time divisions (on and off screen) that can be examined. 5 (Exit) returns to the View Softkeys. Free Run operation and autoranging are not available during �Single Shot� and �Glitch Capture�. Selecting Touch Hold cancels �Single Shot� and �Glicth Capture�.
