|
|
|
Who's Online
There currently are 5992 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Flip-up Shelf
(on some models)
To Raise or Lower the Shelf:
1. Raise the shelf by pulling forward on the lever located at the bottom front of the shelf and lift until the shelf locks into the vertical position. 2. Lower the shelf until it is latched securely in place.
Convertible Vegetable/Meat Drawer, Crisper and Covers
(on some models)
Crisper and Convertible Vegetable Meat Drawers To Remove and Replace Drawers:
1. Slide crisper or meat drawer straight out to the stop. Lift the front of drawer with one hand while supporting the bottom of drawer with other hand and slide the drawer out the rest of the way. 2. Replace the crisper or meat drawer by sliding it back in fully past the drawer stop.
Adjustable Flip-up Shelf
(on some models)
To Raise or Lower the Shelf:
1. Raise the shelf by first sliding it back and down to make it half-width. (You can use the shelf in this position to allow taller items to be stored on the shelf below.) 2. Lift the front of the shelf until it fits securely in place against the back wall. Lower the shelf securely back into position. 3. Pull the front of the shelf forward until it fits into place.
Crisper or Vegetable/Meat Drawer Covers To Remove and Replace Covers:
1. Remove the crisper and meat drawer. Press up in center of crisper glass insert until it rises above the plastic frame. Holding the crisper glass firmly, carefully slide the glass insert forward to remove. 2. Lift crisper cover frame and remove. Repeat steps to remove the meat drawer cover.
3. Replace back of meat drawer cover frame into supports or slides on side walls of the refrigerator and lower or slide the front of the cover frame into place. 4. Slide rear of glass insert into cover frame and lower front into place. Repeat steps to replace the crisper cover.
Deli Drawer
(on some models)
The deli drawer stores raisins, nuts, spreads, and other small items at normal refrigerator temperatures.
Convertible Vegetable/Meat Drawer Temperature Control
The convertible vegetable/meat drawer can be adjusted to properly chill meats or vegetables. The air inside the pan is cooled to prevent �spot� freezing and can be set to keep meats at the National Livestock and Meat Board recommended storage temperatures of 28°- 32°F (-2°- 0°C). IMPORTANT: To extend freshness, wrap meats in airtight, moisture-proof materials before storing. Always store meat as recommended.
To Remove and Replace the Deli Drawer:
1. Remove the deli drawer by sliding it straight out to the stop. Lift the front and slide the drawer out the rest of the way. 2. Replace the deli drawer by sliding it back past the stop.
Adjusting the Control
The convertible control comes preset at the lowest meat setting. To change a control setting: Move the control to the right (colder) or to the left (less cold) as desired. To store vegetables: Set the control to VEG (all the way to the left) to store vegetables at their optimal storage temperatures (which need to be warmer than those for meat).
IMPORTANT: If food starts to freeze, move the control to the left (less cold). Remember to wait 24 hours between adjustments. Doing so gives the temperature of the food time to change.
14
|
|
|
> |
|
