perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Text excerpt from page 19 (click to view)
3. Tilt cover up at the front. 4. Pull cover forward and out.
To replace crisper cover: 1. Fit back of cover frame into supports on side walls of the refrigerator. 2. Lower front of the cover frame into place. 3. Slide rear of glass insert into cover frame and lower front into place.
To replace the cover: 1. Fit notches and rear edge of cover over rear and center crossbars on the shelf. 2. Lower cover into place. 3. Replace the meat drawer.
s
Crisper Humidity Control
(on some models)
You can control the amount of humidity in the moisturesealed crisper. Adjust the control to any setting between LOW and HIGH. LOW (open) lets moist air out of the crisper for best storage of fruits and vegetables with skins. HIGH (closed) keeps moist air in the crisper for best storage of fresh, leafy vegetables.
Crisper and Crisper Cover
(on some models)
To remove the crisper: 1. Slide crisper straight out to the stop. 2. Lift the front. 3. Slide crisper out the rest of the way. 4. Replace the crisper by sliding it back in fully past the drawer stop.
s
Freezer Shelf
(on some models)
To remove the shelf: 1. Lift entire shelf slightly. 2. Move shelf all the way to one side. 3. Tilt other side up and out of shelf supports.
To remove the crisper cover: 1. Remove both crispers. 2. Holding glass insert firmly, grasp one side of crisper cover and lift the other side up from the bottom. 3. Slide the glass insert out to remove. 4. Lift cover frame up and remove. NOTE: Before reinstalling the cover, make sure the U-shaped reinforcement bar is reinstalled.
4. Pull shelf up and out.
To replace the shelf: 1. Tilt the shelf and insert into freezer compartment. 2. Insert one end of the shelf all the way into the center of the shelf supports. 3. Lower other end of shelf and insert into the shelf supports.
