|
|
|
Who's Online
There currently are 6034 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
 ;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
REPLACING BATTERIES
The A-10/A-11 has a dual power supply that consists of main batteries and a back-up battery. Be sure to load the main batteries before using the A-10/A-11 for the first time after purchasing it. Also, replace batteries as soon as possible after they start to lose power. Important! � Never remove both the main batteries and the back-up battery from the A-10/A-11 at the same time. If you do, data stored in memory can be corrupted or lost entirely. � Use two AA-size alkaline batteries or the optional rechargeable battery pack for the main power supply and a CR2032 lithium battery for the back-up power supply. Never use any other types of batteries with the A-10/A-11. � Be sure to keep track of the battery life of both the main batteries and the back-up battery. If the batteries being used for both power supplies are low at the same time, data stored in memory can be corrupted or lost entirely.
Replacing the Main Batteries
1. Make sure the A-10/A-11 is turned off. If the A-10/A-11 is on, press the power switch to turn it off. 2. Close the A-10/A-11 and turn it over. 3. Slide and hold the battery holder release towards �REPLACE BATTERIES� and then carefully slide the main battery compartment from the A-10/A-11.
Note that the main battery holder release actually consists of two separate buttons. Slide and hold both of them towards �REPLACE BATTERIES�.
Grasp the center of the main battery holder when you slide it from the A-10/A-11.
�8�
|
|
|
> |
|
