|
|
|
Who's Online
There currently are 5613 guests and
19 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
A-209R, A-209
7 DIRECT button/indicator
Use this button when you do not wish to pass the output from input terminal equipment through the various frequency adjusting circuits (BASS, TREBLE, BALANCE, LOUDNESS). On : The indicator lights: The signals passing through the input terminals are reproduced without passing through the various frequency adjusting circuits. This results in flat, pure sound which is a more faithful reproduction of the input source. Off : The indicator goes off: The signal passes through the various frequency adjusting circuits.
0 BASS tone control
Use to adjust the low-frequency tone. The center position is the flat (normal) position. When turned to the right, low-frequency tones are emphasized; when turned to the left, low-frequency tones are de-emphasized.
NOTE:
This control does not operate when the DIRECT button is in the on position.
- SPEAKERS B (ON/OFF) button/indicator
Use this button to listen to the speaker system connected to SPEAKERS B terminals. ON : The indicator lights. Sound is heard from the speaker system. OFF : The indicator goes off. No sound is heard from the speaker system. Set to this position when listening with headphones.
8 LOUDNESS button/indicator
Use when listening at low volume levels. On : The indicator lights: Boosts low and high frequencies to give added punch to playback even at a low volume level. Off : The indicator goes off: Should normally be left in this position.
= PHONES jack
NOTE:
This button does not operate when the DIRECT button is in the on position. When using headphones, insert the plug into this jack.
NOTE:
The speakers continue to output sound even when headphones are plugged into this jack. To mute the sound from the speakers, press the SPEAKERS button to OFF.
9 TREBLE tone control
Use to adjust the high-frequency tone. The center position is the flat (normal) position. When turned to the right, highfrequency tones are emphasized; when turned to the left, highfrequency tones are de-emphasized.
~ SPEAKERS A (ON/OFF) button/indicator
Use this button to listen to the speaker system connected to SPEAKERS A terminals. ON : The indicator lights. Sound is heard from the speaker system. OFF : The indicator goes off. No sound is heard from the speaker system. Set to this position when listening with headphones.
NOTE:
This control does not operate when the DIRECT button is in the on position.
31
|
|
|
> |
|
