|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
6
. Measure and cut filler
size. First, measure the distance from inside one window channel to the inside of the other channel and subtract l/4�. Now subtract the width of the air conditioner and divide by 2. This will give you the width to cut each filler board. Be sure to cut the filler boards on the sides opposite the holes. Because the filler boards will be equal in width, they will automatically center your air conditioner in your window.
boards to proper
8
a Place air conditioner
in window by turning unit to one side to get one filler board into window channel (see Figure 36). Now maneuver other filler board into window channel. Reaching through window opening, push filler boards from outside as far toward you as they will go. Be sure to use the foam blocks that are provided. CAUTION: BE SURE UNIT DOES NOT FALL OUT OF WINDOW.
Figure 34
MEASURE DISTANCE FROM INSIDE ONE WINDOW CHANNEL TO INSIDE OF THE OTHER AND SUBTRACT 114�
Figure 36
THE FOAM BLOCKS PROVIDED ARE TO HOLD FILLER BOARD TIGHT AGAINST WINDOW CHANNEL. CUT BLOCKS 114 INCH WIDER THAN CHANNEL AND WEDGE INTO PLACE.
(
i
7 0 Apply
seal strips and attach filler boards. Determine which will be your left and right filler boards. The holes on each board should align with the holes in the side mounting angles. Each filler board should also extend about l/2� above the top edge of the air conditioner cabinet, Now apply 3/8�-wide seal strips on the roomside of each filler board as shown in Figure 35 (i.e. along with bottom edge and window channel edge). Also place a seal strip along the top outside edge of each filler board. Now attach the filler boards to the side mounting angles with the sheet metal screws. Tighten the screws only loosely so the filler boards can be moved back and forth.
9
l
Place side mounting
slides into top mounting
channel. Extend the mounting slides outward into the window channels on both sides (see Figure 37). Pull the air conditioner toward you to position the side mounting slides as far forward in the window channels as possible. Now mark and make a 3/32� pilot hole for each wood screw used to secure the slides in the window channels. CAUTION: BE SURE UNIT DOES NOT FALL OUT OF WINDOW.
Figure 35
1
13
BOARD
|
|
|
> |
|
