Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Text excerpt from page 7 (click to view)
Attach Side Curtains
1. Locate the bag of screws provided. 2. Insert the top and then the bottom of the right-hand curtain housing in the top and bottom curtain guides on the air conditioner cabinet.
4. While the right-hand curtain is still extended, insert #10 x ¹��" pan-head Phillips screws into the top and bottom slots of curtain. Screw curtain to the top and bottom holes in air conditioner cabinet. NOTE: Some curtains may have 2 slots at each end. You will be able to see a mounting hole through the correct slot. 5. Slide the curtain housing into the guides as far as it will go. 6. Repeat the above steps for the left-hand curtain.
Back View
A B
Attach Foam Adhesive Seal
Attach the foam adhesive seal along the bottom of the curtain bottom channel.
A
A. Curtain housing B. Curtain guides
B
A. Curtain housing B. Foam adhesive seal
Bottom View
Install Cabinet into Window
A B
A. Curtain housing B. Curtain guides
NOTES: s Handle the air conditioner gently. s Be sure your air conditioner cabinet does not fall out of the opening during installation or removal.
s
3. Extend the right-hand curtain outward so you may insert the first screw through the middle hole of the curtain. Using #10 x ¹��" pan-head Phillips screw, screw the curtain to the middle hole in the air conditioner cabinet. NOTE: This screw is required to correctly attach the curtain (top to bottom) to the air conditioner cabinet.
The location where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded 3 prong outlet. Do not block the louvers on the front panel.
s s
Do not block the louvers on the outside of the air conditioner. 1. Center empty cabinet in window. Check that lower rail of air conditioner cabinet is behind and against back side of windowsill. Maintain a firm hold on the air conditioner cabinet. Lower window sash to hold cabinet in place. 2. Measure the distance between the right-hand side of the cabinet and the inside of the window channel. 3. Repeat for the left side. Adjust the cabinet until the distance on each side is the same.