|
|
|
Who's Online
There currently are 5742 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
;
Nice pdf file of the manual sent promptly. Thanks.
9-4. EVF Sub contrast Adjustment
1. 2. 3. 4. Set SW109 to �FLUSH� side on the VFK1308P. Connect the oscilloscope to �VCC41� and �VCC9� on the VFK1308P. Open the �EVF adjustment menu�. Select �4. Sub contrast adjustment� in the EVF adjustment menu, and then press the �Enter� key.
5. Adjust level difference between �a� (VCC41) and �b� (VCC9) to become 0±50mV as shown in figure. Note: 1) Signal level can be adjusted by press arrow keys on keyboard. 2) Waveform (figure) can be displayed by press F2 key. 6. When adjustment is finished, press ENTER key to adjusted data write to EEPROM, then change the display indicated as below.
7. Connect the oscilloscope to �F_VCC� and �VCC9� on the VFK1308P. 8. Adjust level difference between �a� (F_VCC) and �b� (VCC9) to become 0±50mV as shown in figure. Note: 1) Signal level can be adjusted by press arrow keys on keyboard. 2) Waveform (figure) can be displayed by press F2 key. 9. When adjustment is finished, press ENTER key to adjusted data write to EEPROM.
ELE-42
|
|
|
> |
|
