|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Adjusting the white balance and black balance (continued) Adjusting the black balance
The black balance needs to be adjusted in the following cases: O When the unit is used for the first time O When the unit is used after it has not been used for a prolonged period of time O When the unit is used in an ambient temperature which has fluctuated significantly O When the value selected for the gain switch has been changed O When the super gain setting has been performed using the USER button O When the gamma ON/OFF setting has been changed O When the frame rate setting has been changed
3 While the adjustment is in progress, the following
message appears on the viewfinder screen (but only when �2� or �3� has been set as the display mode). <Note> While the adjustment is in progress, the lens aperture is automatically set to CLOSE.
ABATV B CIE
Message appearing while the adjustment is in progress
4 Adjustment is completed in several seconds. 1 Set the switches as shown in the figure.
(A message similar to the one shown in the figure now appears.) The adjustment value is automatically saved in the memory.
ABO B K
Message appearing upon completion of the adjustment
OUTPUT: CAM
2 Set the AUTO W/B BAL switch to the ABB position,
and then release it. The switch returns to the center, and the adjustment is performed.
AUTO W/B switch
<Notes> O When using a lens with an auto aperture, check that the lens connector has been connected. O When using a lens with an auto aperture, the aperture will be automatically set to where the light is blocked while the black balance is being adjusted. O When using a lens with a manual aperture, the aperture must be fully stopped down first before the black balance is adjusted. O While the black balance is being adjusted, the gain selector circuit is switched automatically. Flicker or noise may appear on the viewfinder screen, but this is not indicative of malfunctioning. O If black shading is not satisfactory even with ABB OK, open the BLACK SHADING screen of FILM (CAM) MAIN MENU 4, and adjust the black shading. (Refer to page 111.) O When the super gain has been set to ON, the black balance is executed at the preset position in the white balance memory. O When the AUTO W/B BAL switch is pressed again to the ABB side when the black balance is being adjusted automatically (ABB ACTIVE), the adjustment operation will stop. The adjusted value in this case is the value before automatic adjustment was performed.
56
|
|
|
> |
|
