|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
;
It is OK, this manual help me to repair my dynacord
 ;
Good manual. Even it is an old printed manual, it is well scanned and complete, with all drawings, schematics and parts list. Very good return for the cost.
;
I'm very satisfied with my purchase. It resolved my problem. Owner-manuals.com is a very very good place.
Thank you!
;
Veramente completo, dettagliato e perfetto nella visione. Perfect, thanks!
ADJUSTMENTS
4-5. CDP MODE TEST & ADJUSTMENT METHOD
Definition of Mechanical Mode
No
1
MODE
STOP MODE
DEFINITION & STATUS
- Disc haven�t been inserted or disc have been ejected. When disc shall be transported into the unit Mechanism shall be fixed at this mode. - Loading device can insert disc thru the slot. - Floating device being locked. - Disc have been inserted thru the slot in front of unit. It is transient state between STOP mode and PLAY mode. - If disc should be inserted at the state of POWER ON, disc shall be loaded by a series of operation of specified device. - Disc shall be played. - Floating device being unlocked.
2
LOADING MODE
3
PLAY MODE - After disc have being clamped on the turn-table, disc shall be rotated.
4
EJECT MODE
- Disc is to be ejected at this mode. It is transient state between PLAY mode and STOP mode. - If disc should be mounted at the state of POWER ON and commanded by EJECT key, disc shall be ejected thru the slot by a series of operation of specified device.
Standard values / Play-ability test
No ITEMS SPECIFIED VALUES, CONDITIONS STANDARD VALUES RELIABILITY LIMITS
1 2 Loading Time Ejecting Time 7sec + 3sec < 5 sec < 17 sec < 15 sec From insertion up to make sound. (TCD-784) From track No.1 Between the EJECT command and the disc eject completion. (TCD-784) From out-most Track, Between the PLAY command of in-most Track and marking sound. Shall be measure when the center of Disc is correspond with the center of Roller. Shall be measure when the center of Disc is correspond with the center of Roller.
TEST CONDITIONS, REFERENCES
CONNEC TION Fig.6 Fig.6
3
Access Time
6sec + 3sec
< 15 sec
Fig.6
4
Disc Take-up Force
> 120g > 120g
> 90g During play in low temp. > 70g During play in low temp. > 130g
Fig.6
5
Disc
> 80g
Fig.6
6 7
Clamping Force Mechanical Noise
> 130g Loading
Fig.6 Fig.6
Eject -Test should be performed in no reverberation If anything is not < 75dB(A) error, shall not room at the noise level of less than 20dB(A). Play < 40dB(A) -Test should be performed at the 50cm in front defined. Access < 70dB(A) of the unit. -IHF-A MODE (RMS-FAST)(TCD-792D) 12
|
|
|
> |
|
