|
|
|
Who's Online
There currently are 5837 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great Manual. This manual is available no where else. It was exactly what I was looking for. Only in German.
 ;
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
;
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
;
Хорошее качество сканирования.
Мануал пришел часов эдак через 12. В целом доволен.
;
Fantastic quality and impressive delivery time. Based on this manual, I recommend this service without hesitation! Five Stars for certain.
3gb53241a.fm5 Page 43 Thursday, December 19, 2002 3:09 PM
INSTALLATION
ADJUSTMENT TO DIFFERENT TYPES OF GAS
If a different type of gas to the type shown on the rating plate and on the orange sticker affixed to the top of the cooktop is used, the cooktop must be converted to work with the new gas type. Remove the orange sticker and affix it to the instructions booklet, which must be retained for the lifetime of the appliance. Use pressure regulators suitable for the gas pressures indicated in the separate Product Description Sheet. 1. The gas nozzles must be changed by After Sales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After Sales Service. 2. Connect the cooktop to the gas shut-off valve by means of a pipe suitable for the type of gas used, in compliance with current local regulations. 3. Adjust the minimum setting of the taps. Note: when liquid petroleum gas is used (G30/G31), the minimum gas setting screws must be tightened as far as they will go.
Replacing the injectors (see table in the enclosed Product Description Sheet)
1. Remove grids (A). 2. Extract burners (B). 3. Using a socket spanner of the appropriate size, (C), unscrew the injector to be replaced. 4. Replace it with the injector suitable for the new type of gas. 5. Re-assemble the injector in (D). 6. For models equipped with a triple crown burner, proceed as shown in figure. � Remove the two screws (F) followed by the cap (G) then replace both injectors (D) as previously described. Replace the cap (G), ensuring the seal is properly positioned before attempting to use the cooktop. Before installing the cooktop, remember to affix the gas calibration plate supplied with the injectors in such a way that it covers the existing information relating to gas calibration
Adjusting minimum gas setting of taps
1. To ensure that the minimum setting is correctly adjusted, remove knob (E) and proceed as follows: � tighten (-) to reduce the height of the flame; � loosen (+) to increase the height of the flame; The adjustment must be performed with the tap in minimum gas setting position (small flame) . Upon completion of adjustment, reseal using sealing wax or an equivalent material. 2. The primary air of the burners does not need to be adjusted. 3. After the adjustment of the minimum gas setting, light up the burners and turn the knobs from max. position to min. position to check the stability of the flame. 43
Black Process Plate
|
|
|
> |
|
