|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
- Exteriors
- Original Cover Unit
- Operation Panel
- Side Door Unit
- Optical Frame 1
- Optical Frame 2
- LSU Unit
- Mirror Holder Unit
- Delivery Paper Guide Unit
- Middle Frame
- Base Plate Unit 1
- Base Plate Unit 2
- Fusing Unit
- Drive Unit
- Single Manual Paper Feeding Cover Unit AL - 1000
- Multi Manual Paper Feeding Cover Unit AL - 1001/AL - 1200
- Single Manual Paper Feeding Unit AL - 1000
- Multi Manual Paper Feeding Unit AL - 1001/AL - 1200
- Socket Holder Unit
- TC Case Unit
- 250 Sheets Tray
- Harness
- Packing Material & Accessories
- MCU PWB
- Operation PWB
- MFD Sensor PWB
- POD Sensor PWB
- PPD1 Sensor PWB
- PPD2 Sensor PWB
- DC Power Supply PWB
There are currently no product reviews.
 ;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
AL-1000/1010
5. The solenoid turns off to close the gate and return to the initial state.
Process unit new drum detection mechanism
1. When the power is turned on, the detection gear 38T is rotated in the arrow direction by the detection gear 20T to push the microswitch (process detection switch) installed to the machine sensor cover, making a judgement as a new drum.
Gear 20T
Gear 38T
A C
Process detection switch
OFF MPFS
C. Conditions of occurrence of paper misfeed
(1) When the power is turned on: PPD or POD is ON when the power is turned on. (2) Copy operation a. PPD1 jam 1) PPD1 does not turn off within 4 sec after turning on the resist roller. b. PPD2 jam 1) PPD2 is off immediately after turning on the resist roller. 2) PPD2 does not turn off within 1.2 sec after turning off the resist roller. 1) POD does not turn on within 2.9 sec after turning on the resist roller. 2) POD does not turn off within 1.5 sec � 2.7 sec after turning off PPD2.
2. When the detection gear 38Y turns one rotation, there is no gear any more and it stops. The latch section of the 38T gear is latched and fixed with the projection of the process cover.
Gear notch
c. POD jam
Gear pawl Projection Gear notch
Projection Gear pawl
7-8
|
|
|
> |
|
|
Parse Time: 0.252 - Number of Queries: 134 - Query Time: 0.069
