|
|
|
Who's Online
There currently are 6018 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
START (Normal mode)
L1
Press the #/P key. Press the START key. Press the asterisk (*) key.
1
� In the cause of SIM which is set by touch panel, the
changed content can be stored by the following key, touch. [OK] key Other item selection
Press the clear key.
4
The changed content is stored.
· · · � � key
Press the asterisk (*) key. Do you want to end the Standby for entry of SIM code. Enter the main code of SIM with the 10-key. The main code of SIM is displayed.
3 YES
simulation ? Press the clear all key.
NO
The simulation mode is canceled. Returns to START (Normal mode). Do you want to perform another simulation ?
YES NO
Press the START key.
2 NO
Is there a sub code ?
YES
Press the CUSTOM SETTINGS key
Standby for entry of SIM sub code. Enter the sub code of SIM with the 10-key.
2
Is it the same simulation ?
NO
YES
3
Press the START key.
Press the CUSTOM SETTINGS key
Is there a item selection?
YES
NO
4
Select the mode and the item with the � � key and the item key.
YES
Operation check ? Press the START key.
NO
Operation is made according to the selected mode and item. Operating conditions check ?
NO YES
Press the START key. Operation is made according to the selected mode and item. Data clear ?
NO
If "Operation condition check" refer to "Sensor display", this process is not necessary.
Press the START key.
NO
Select "YES". The selected mode and the item are cleared.
Adjustments or setting (counter data change) ?
YES
NO
The display is made according to the selected mode and the item.
Operation is made according to the select ed mode and the it (Other modes)
Do you want to change the content ?
YES
NO
1
Enter the new setting and adjustment values.
L1
AR-M236/M276/M237/M277 SIMULATION 8 - 2
 $4.99 ARM236 SHARP
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…  $4.99 AR-M236 SHARP
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|
