SHARP AR-PN1C
Service Manual

(7)
1)

Staple/Fold Drive Unit
Open the front door, and slide out the stapler unit slightly to the front.

10) Disconnect the two connectors [18], and free the harness [20] from the edge saddle [19].
[18]

1

2

[20] [18] [19]

11) Remove the three screws [21].
[21]

2) 3) 4) 5)

Remove the screw [3], and detach the interface retainer [4]. Free the six harness retainers [5], and disconnect the connector [6]. Free the harness [7] from the harness retainer [5]. Free the harness [7] from the edge saddle [8]; then, disconnect the two connectors [9].
[21]

[9]

[7]

[8]

[21]

[5] [6] [7] [3]

12) Remove the screw [22], and detach the staple/fold drive unit [23].

[7]

[5]

[4] [5] [7] [5]

6) 7) 8)

Release the harness retainer [10], and disconnect the connector [11]. Free the harness [12] from the harness retainer [10]. Free the harness [12] for the edge saddle [13]; and disconnect the two connectors [14].
[14] [11]

[22] [23]

(8)
1) 2) 3) 4)

Feed Motor Unit
Remove the rear cover. (See A.(3).) Open the harness retainer [1], and disconnect the two connectors [2]. Remove the screw [3], and detach the harness guide [4]. Remove the three screws [5], and detach the feed motor unit [6].
[5]

[12] [13] [10]

9)

Remove the screw [15], and free the claw [17] of the harness guide from the long angle [16] of the base plate.
[15]

[5] [3]

[4] [6]

[16]

[17]
[1]

[2]

MX-FNX2/AR-PN1/MX-RBX1 DISASSEMBLY AND ASSEMBLY 6 � 7