The purchased manual is an scan of the original Panasonic paper-based Service Manual. Unfortunately the contrast is not perfect, but I am satisfied anyway!
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
Text excerpt from page 17 (click to view)
Item RGB MODE HORIZONTAL SHIFT adjustment
Measuring instrument Signal generator Remote control unit
Test point
Adjustment part RGBH
Description (1) Input R/G/B circle pattern signal via video input terminal. (2) Press [AV] key on the remote control unit, force the TV to RGB mode. (3) Enter the SERVICE MENU. (4) Select RGBH with the [ / ] key. (5) Adjust RGBH with the [ / ] key until the circle pattern is horizontally centered.(A=B) (6) Check and readjust RGBH item if the adjustment becomes improper after some other geometric adjustments are done.
A
B
VERTICAL SIZE Signal OFFSET generator adjustment (60Hz) Remote control unit
Very close
VSOF
(1) Receive a NTSC-M cross-hatch pattern of vertical frequency 60Hz. (2) Enter SERVICE MENU. (3) Select VSOF with the [ / ] key. (4) Adjust VSOF with the [ / ] key until the horizontal black lines on both the upper and lower part of the pattern become very close to the opper anr lower horizontal sides of picture size and nearly about to disappear. (5) Check and readjust VSOF item if the adjustment bocomes improper after some other geometric adjustments are done.
Screen size
Picture size 100%
Very close
VERTICAL POSITION OFFSET adjustment (60Hz)
Signal generator Remote control unit
VPOF
C
(1) Receive a NTSC-M circle pattern of vertical frequency 60Hz. (2) Enter the SERVICE MENU. (3) Select VPOF with the [ / ] key. (4) Adjust VPOF with the [ / ] key until the picture is vertically centered.(C=D) (5) Check and readjust vertical position item if the adjustment becomes improper after some other geometric adjustments are done.
