|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
5
6
7
8
2.2 Disc centering mechanism
A
1. In the case of a 12 cm disc, the centering arm R L will open by the disc being transported and both the lock arm R L being pushed. Furthermore, the disc will be centered by the stopper of either the clamp arm or the centering arm R and stopped, and the clamping motion will be taken.
12 cm DISC positioning section
B
Lock arm
Lock arm Centering arm
Centering arm
Clamp arm
C
2. In the case of an 8 cm disc, if a disc is inserted being shifted to the left or the right, the disc will first hit the lock arm R or L. As the lock arm R and L are coupled via the centering arm R and L and the lock will not be released unless both are pushed, the disc will be restricted by the fixed lock arm and centered. The disc pushes out the detection arm while being centered, the disc stops at a position where the motion of the detection arm is completed, and the clamping motion will be taken.
D
E
8 cm DISC positioning section
F
CX-3212
5 6 7 8
21
|
|
|
> |
|
