ARCAM AVR300
Owner's Manual

Sub Stereo: This setting allows the volume level of the subwoofer to be adjusted for when the subwoofer is being used with 2-channel (stereo) sources. The subwoofer level for stereo music often needs to be set at a lower level than that for cinema use; use this trim setting, with a stereo source, to reduce the subwoofer output in stereo playback to an acceptable level. The level required depends on various factors such as speakers, the types and styles of music to be played and personal taste. DVD-A Sub Level: This setting allows compensation for subwoofer level gain from external decoders or sources (such as DVD-A players). When decoding digital inputs, the AVR300 follows the convention for products of this type and sets the subwoofer level 10dB higher than that of the other channels. Source products such as DVD-audio players do not follow this pattern, however, setting the subwoofer level to be the same as the other channels. This means that switching from material that has been decoded by the AVR300 to that decoded externally may mean that the subwoofer sounds very quiet. This setting provides for the removal of that difference by allowing the subwoofer level of the DVD-A (multi-channel) input to be raised by 10dB.

n n

NORMAL: No gain compensation. This allows the DVD-A sub level to pass directly to the output with no gain adjustment. +10DB: This increases the DVD-A (multi-channel input) sub level by 10dB

If you are using the AVR300 in combination with the multi-channel analogue outputs of an Arcam DVD-A player, then this item should be set to �+10dB�.

4 � Speaker Delay Settings
The relative positioning of speakers within a room may mean that sound from some speakers arrives at the listener later than sound from others. By altering Sub woofer the delay settings for the different speakers, this difference in arrival time Centre F can be reduced or eliminated. ron righ t When setting the delay, it should be t
e.g. 3m (9ft)

ont Fr ft le

e.g. 4m (12ft)

imagined that the listener is sitting in a circle of the speakers; the delay indicates the distance of the speaker from the listener.

Surr left

e.g. 2m (6ft)

Surr right

The speaker distance control can be used to set automatically the appropriate time delays required for all the speakers in your system. To use this, measure from the usual listening position to the front of each individual speaker in the system and enter this value in the appropriate place. The measurements can be entered either in feet or metres, as selected from the �General Settings� menu page. An alternative to using the speaker distance control is to enter the delays manually in milliseconds.

Surr back left

Surr back right

Distance measurements for 5.1 [and 7.1] speaker delay settings

Note that the delay adjustment is not a substitute for proper speaker placement, but can help to ensure accurate and correct signal arrival times from all the channels to the primary listening position. No measurement can be entered for a speaker that is not selected in the previous �Speaker Sizes� menu.

Note: Only enter these delay settings once you have specified which delay units (i.e., Time, Imperial or Metric) you will be using. The delay settings will be lost if the units are changed. If the delay units are set to Time, then enter the delay in milliseconds for each channel.

AVR300 E-14