WHIRLPOOL AWM 506
Quick Start

CONSUMPTION DATA Temperature Selector (°C) Cotton Cotton Cotton Synthetics Synthetics Delicates Wool Silk 95 60 40 60 40 30 30 30 Load (kg) 4,5 5,0 4,5 2,0 2,0 1,5 1,0 1,0 Water (l) 49* 46 44 55 55 60 60 60 Energy (kWh) 1,70 0,95 0,60 0,80 0,60 0,50 0,30 0,30 Approx. Programme Duration (hours : minutes) 2:05 2:20 2:05 1:30 1:20 0:45 0:40 0:50

PROGRAMME CHANGE To reselect a programme when a cycle has already begun: 1. Switch off the appliance by pressing the �On/Off� 2. 3. button. Select the new programme. Start the programme by pressing the �On/Off� button.

NOTES AND INDICATIONS FOR USE � WATER LEVEL It may not be visible as the cycle is optimised for a minimum water consumption without compromising washing results. SPIN SPEED CONTROL Spin speed may be reduced automatically or may even be excluded in the case of small loads with highly absorbent garments (e.g. bathrobes, bathmat). This control avoids cloth and machine damage and excessive vibrations and consequent noise produced by the machine due to load unbalance: by selecting high spin speeds the noise level increases. � MOTOR NOISE The running noises of the new, electronicallycontrolled motor are not the same as the ones you are used to from your old appliance. Don't be surprised - modern technology has a modern sound. CLEANING THE FILTER To ensure an impeccable function of the pump, check the filter regularly and clean it if necessary.

Programme

�

END OF WASH CYCLE 1. 2. 3. 4. At the end of the programme the programme selector moves to the stop position. To unload the machine wait for the door to unlock (about 1 minute). Switch off the appliance, open the door and take out the laundry. Close the tap and leave the door ajar to allow the drum to dry out.

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

�

ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter �Detergents and Additives� in the booklet. 1. Open the tap. 2. Set the programme selector to the desired programme. 3. Turn the temperature selector to the desired temperature. 4. Special options can be selected. 5. Check that the door is well closed and turn on the washing machine by pressing the �On/Off� button. The indicator lights up, indicating that the washing machine is on.

SELECT ANY DESIRED OPTION �Half Load� button � Reduces water consumption, above all during rinsing. � Suitable for lightly-soiled laundry and small loads (max 3 kg). Note: Reduce the detergent quantity. �No Spin� button � Especially for delicate garments to avoid wear and tear caused by the spin. Note: with the �Cotton� and �Synthetics� programmes a short spin cycle is provided in any case, even if the exclusion has been selected, in order to optimize rinsing results.

Whirlpool is a registered trademark of Whirlpool USA.

5019 301 10202