|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Limiters
�Releasing the limiters
The set limits can be release by taking the following steps. � Releasing the upper limit of operating range 1. While holding down the OK button on the controller, press TRACING/PRESET MEMORY button 47 . 2. The release is completed when TRACING/PRESET MEMORY button 50 [LIMIT OFF] lights. � Releasing the lower limit of operating range 1. While holding down the OK button on the controller, press TRACING/PRESET MEMORY button 46 . 2. The release is completed when TRACING/PRESET MEMORY button 50 [LIMIT OFF] lights. � Releasing the left-most limit of operating range 1. While holding down the OK button on the controller, press TRACING/PRESET MEMORY button 44 . 2. The release is completed when TRACING/PRESET MEMORY button 50 [LIMIT OFF] lights. � Releasing the right-most limit of operating range 1. While holding down the OK button on the controller, press TRACING/PRESET MEMORY button 45 . 2. The release is completed when TRACING/PRESET MEMORY button 50 [LIMIT OFF] lights.
�Setting the limiter again
The same steps set and release the limiter alternately. To set the limiter again, release the current limit and set it again. A set limit can be set again by taking the following steps. 1. Release the desired limit to be set again, referring to �Releasing the limiters�. 2. Set the limit again, referring to �Setting the limiters�.
33
|
|
|
> |
|
