|
|
|
Who's Online
There currently are 6026 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Section
Digital Signal Processor
07
Using balance adjustment
You can select a fader/balance setting that provides an ideal listening environment in all occupied seats. 1 Press p to select Fad. Press p until Fad appears in the display.
SLA +4 SLA 4 is displayed as the source volume is increased or decreased.
Notes ! Video CD and CD are set to the same source level adjustment volume automatically. ! Analog4, Analog5 and Analog6 are set to the same source level adjustment volume automatically.
# If the balance setting has been previously adjusted, Bal will be displayed.
2 Press r or q to adjust front/rear speaker balance. Each press of r or q moves the front/rear speaker balance towards the front or the rear. Fad :F25 Fad :R25 is displayed as the front/ rear speaker balance moves from front to rear.
# Fad : 0 is the proper setting when only two speakers are used.
Using the dynamic range control
The dynamic range refers to the difference between the largest and softest sounds. The dynamic range control compresses this difference so that you can clearly hear sounds even at low volume levels. ! The dynamic range control is effective only on Dolby Digital sounds. 1 Press p to select DRC. Press p until DRC appears in the display.
# When playing other than the DVD disc, you cannot switch this mode.
3 Press m or n to adjust left/right speaker balance. When you press m or n, Bal : 0 is displayed. Each press of m or n moves the left/right speaker balance towards the left or the right. Bal :L25 Bal :R25 is displayed as the left/ right speaker balance moves from left to right.
Adjusting source levels
SLA (source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. 1 Press p to select SLA. Press p until SLA appears in the display. 2 Press r or q to adjust the source volume. Each press of r or q increases or decreases the source volume.
2 Press r to turn the dynamic range control on. DRC ON appears in the display. Dynamic range control is now on.
# To turn dynamic range control off, press q.
English
En
21
|
|
|
> |
|
