PHILIPS AZ1123/78
Owner's Manual

English Controls/Power Power Supply General Operation/Tuner CAUTION
WARNING: Always check you have Supplied Accessories General operation completely switched set, before Switching on off and selecting the � AC power cord Use of controls adjustments or you change or disconnect power supply. function performance of procedures other 1 To select your sound source, adjust the the type plate located on the Source selector to: CD, FM or MW. 1 Source selector: CD, FM, MW or OFF Source selector to OFF position. cord if you want to conserve battery life. 2 If your set is equipped with a voltage selecMake sure you remove the plug from the set Adjust the sound with the VOLUME control. and wall outlet before inserting batteries. § � Adjusting volume tor, adjust the selector so that it matches 2 2; � starts or pauses CD playback 3 Connect the power cord to the � selects the next/previous track local power supply. If it does not, consult your � selects CD or radio (FM/MW) source of dealer or service center. sound Power Supply Using AC power

1 Check if the power voltage, as shown on

than herein may result in unsafe

Top/front panels (See 1) operation.

2 To switch off the set, adjust the bottom of the set, corresponds to your

� off switch Whenever convenient, use the power supply

with the local power supply. � fast searches forwards/backwards Batteries (not included) AC MAINS~ inlet and the wall socket.The Radio reception 1 Open the battery door and insert 6 batteries, (press hold button) set is now connected and ready for use. 1 Adjust the Source selector to FM or PROG � programs tracks and reviews the type R-14, UM-2 or C-cells, (preferably 4 To switch the set off completely, withdraw MW to select your desiredwaveband. program alkaline) with correct polarity as indicated 2 Turn TUNING tune to a station. power cord from the wall socket. 9 � stops CD playback; 5 Install the unit near the AC outlet and where by the "+" and "�" symbols inside the com� erases a CD program partment (See 1). the AC power plug can be easily reached. Helpful hints: teries are firmly correctly in place.The socket to protect your set during heavy � For FM, extend, incline and turn the telescopis now ready to operate. thunderstorms. ic antenna for best reception. Reduce its length if the signal is too strong. 3 Display � shows the CD functions � Disconnect power cord from wall 2 Replace battery door, making sure the batTo improve radio reception 4 REPEAT � repeats a track/ CD program/entire CD. 5 SHUFFLE � plays all tracks in random order The type plate is located on the � Incorrect use of batteries can cause 6 OPEN�CLOSE � opens/ closes CD Direct this antenna for best reception by compartment or cause the batteries to burst: door � Do not mix battery types: e.g. alkaline with carHelpful hints: turning the whole set. 7 TUNING � tunes to radio stations bon zinc. Only use batteries of the same type � To avoid unnecessary energy consumption, 8 VOLUME � adjusts volume level � 1) Remove the batteries if the set is not to be 9 Telescopic antenna � improves FM reception Batteries contain chemical substances, so 0 Battery door � open to insert 6 x 1.5V they should be disposed of properly. R-14/ UM-2/ C-cells ! p � 3.5 mm stereo headphone socket Helpful hints: The speakers will be muted when headphones are connected to the set. @ AC MAINS~ � inlet for power cord # Voltage selector � (not for all versions) adjust to match the local voltage 110/220V before plugging in the set � When inserting new batteries, do not try to mix after using the set. old batteries with the new ones. for the set. always adjust the Source selector to OFF

bottom of the set. electrolyte leakage and will corrode � For MW, the set uses a built-in antenna.

Back/bottom panels (See
used for a long time.