I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 7 (click to view)
DIGITAL TUNER
Changing tuning grid (some versions only)
In North and South America the frequency step between adjacent channels in the AM and FM band are 10 KHz and 100 KHz respectively. In the rest of the world this step is 9 KHz and 50 KHz. Usually the frequency step has been preset in the factory for your area. 1. Check that the set is in the TAPE/OFF position and switched off. 2. To select 9KHz : Simultaneously, press PROG and REPEAT on the set. 3. Switch the set on to TUNER and then release the controls. � To select 10KHz : Repeat steps 1-3 but in step 2, simultaneously, press PROG and TUNING § on the set. � When you tune to radio stations, the display shows tuning in either steps of 9 or 10. � All preset stations will be affected and you may need reprogramme the preset stations. English
CD PLAYER
STOP PLAY�PA USE
CASSET TE RE CORD ER
1 57 5
O
PROG
BA LOW T
SO
FM
UN
AM LW
D CONTR OL CE N
PROG
VOL
TER
REMO SEN TE SOR
TUNE R PRES ET
�
SHUFFL E SEAR CH
�
SHUFFL
E
BAND
REPEAT
D
Playing a CD
1. Select CD source. 2. Press OPEN�CLOSE to open the CD door. � Display: when you open the CD door. 3. Insert a CD or CD-R(W) with the printed side facing up and press OPEN�CLOSE to close the CD door. � Display: as the CD player scans the contents of a CD. The total number of tracks and playing time are then shown. � Display: is shown if the CD R(W) is not finalised. 4. Press PLAY�PAUSE 2; (on the remote control 2;) to start playback. � Display: Current track number and elapsed playing time of the track during CD playback. 5. To interrupt playback press PLAY�PAUSE 2;. Press PLAY�PAUSE 2; again to resume play. � The display freezes and the elapsed playing time flashes when playback is paused. 6. To stop CD playback, press STOP 9 Note: CD play will also stop when: � the CD door is opened; � the CD has reached the end (unless you have selected REPEAT ALL); � you select another source: TAPE / TUNER.
CD RADIO CASS ETTE
