|
|
|
Who's Online
There currently are 6030 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
Disassembly
Product Family B89
5.
Lift the lens completely away from the flip as shown in Figure 18B.
G
Do not remove the transparent protective film from the front of the new lens. This film prevents damage to the lens during service and handling. It is to be removed only by the end user. 6. 7. 8. To replace, insert the fingers at the top of the lens into the corresponding recess on the flip housing and rotate the lens down until the 2 catches snap into place. Replace the 3 T-4 screws and tighten securely. Do not overtighten. Replace the antenna, SIM and battery as described in the procedures.
Removing and Replacing the Real Time Clock (RTC) Battery
1. Remove the battery, SIM, antenna, and lens assembly as described in the procedures.
DISPLAY BOARD
RTC BATTERY DISASSEMBLY TOOL
010435o
Figure 19. Removing the RTC battery 2. Using the flat end of the disassembly tool, gently pry the RTC battery from its socket on the display board. See Figure 19.
G
Use only non-conductive tools, such as the plastic disassembly tool and the plastic tweezer, when removing and replacing the RTC battery. 3. To replace, insert the new RTC battery into its socket on the display board. The plastic tweezer may be used to replace the RTC battery. Be sure the
28
May 15, 2001
6881038B20
|
|
|
> |
|
