|
|
|
Who's Online
There currently are 5538 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
BM 2609140334 10-06
10/26/06
11:32 AM
Page 3
Extension Cords
necessary, a cord with adequate size conductors that is capable of carrying the current necessary for your tool must be used. This will prevent excessive voltage drop, loss of power or overheating. Grounded tools must use 3-wire extension cords that have 3-prong plugs and receptacles. NOTE: The smaller the gauge number, the heavier the cord.
!
WARNING If an extension cord is
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT ALTERNATING CURRENT TOOLS
Tool�s Ampere Rating 3-6 6-8 8-10 10-12 12-16 Cord Size in A.W.G.
Cord Length in Feet
Wire Sizes in mm2
Cord Length in Meters
25 18 18 18 16 14
50 16 16 16 16 12
100 150 16 14 14 14 � 14 12 12 12 �
15 0.75 0.75 0.75 1.0 �
30 0.75 1.0 1.0 2.5 �
60 1.5 2.5 2.5 4.0 �
120 2.5 4.0 4.0 � �
�SAVE THESE INSTRUCTIONS�
Functional Description and Specifications
BATTERY PACK
Charger Voltage rating Battery pack
BC430 120 V
60 Hz
BAT400 thru BAT450
FIG. 1
RED LIGHT
CHARGER
GREEN LIGHT
Charging Battery Pack (BC430 30 Minute Charger)
Plug charger cord into your standard power outlet, then insert battery pack into charger. The charger�s green indicator light will begin to �BLINK�. This indicates that the battery is receiving a fast charge. Fast-charging will automatically stop when the battery pack is fully charged. When the indicator light stops �BLINKING� (and becomes a steady green light) fast charging is complete. The battery pack may be used even though the light may still be blinking. The light may require more time to stop blinking depending
on temperature. When you begin the charging process of the battery pack, a steady red light could also mean the battery pack is too hot or too cold. The purpose of the green light is to indicate that the battery pack is fast-charging. It does not indicate the exact point of full charge. The light will stop blinking in less time if the battery pack was not completely discharged. When charging several batteries in sequence, the charge time may slightly increase. When the battery pack is fully charged, unplug the charger (unless you're charging another battery pack) and slip the battery pack back into the tool.
-3-
|
|
|
> |
|
