|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
1-3. Removal of Cabinet
1-3. Removal of Cabinet
1-3-1. Removal of Front Panel
1. Turn the power off. 2. Unplug the appliance from the outlet. 3. Loosen the locking screw on the front panel using a flat-blade screwdriver. 4. Pull the locking screw toward you and open the front panel.
1-3-2. Removal of Upper Chassis
1. 2. 3. 4. Turn the power off. Unplug the appliance from the outlet. Remove the front panel. (Refer to the Section 1-3-1.) Remove the two screws and the harness clamper shown in the figure.
Front panel B 3x6 Harness clamper Locking screw
5. Disconnect the connector CN701 on the DEC-99 board. 6. Push the hinge shaft in the direction of the arrows while holding the front panel, and remove the front panel.
5. Remove the four screws, and remove the rack angles of both sides. 6. Remove the 15 screws shown in the figure, and pull up the upper chassis.
Upper chassis B 3x6 B 3x6 B 3x6 B 4x10
Front panel CN701
B 3x6 B 3x6 Rack angle
B 4x10
B 3x6
Rack angle
Hinge shaft
DEC-99 board
1-2 (E)
BDX-D1000
|
|
|
> |
|
