WHIRLPOOL BDNT22L9
Owner's Manual

extended petiod of time, it Is best to shut off the water supply. REMOVING ICE CUBE TRAY If ice cubes seem to be stickingin the tray, it is poeaible that the water in your area contairs an abundance of mineral deposits and is leaving a film residuein the tray. Wipe the tray pockets with a clo_ soaked in vinegar until file film is cleaned out. ff the residue seems heavy, clean the tray each time you clean your refrigerator, � ' In order to remove the tray for cleaning, 1. Remove the panel in front of the ice maker by pulling the bottom right hand corner of the panel forward. Then pull the top right hand corner forward and slidethe panel out of the sockets on the Jeftside of the freezer liner, Prevent ice cubes from mi_ing your glass by holding it as high as po_ible |_st below the ice chute). Press the glass'against the padded lever at the right side of the fountain. To stop dispeneing ice, release pressurejust enough to stop the dispenesr motor and leave the glass in place to hold the door open until ice stops falling. With a little practice, you will leam to anticipate when to release pressure to prevent an unwanted dispenes of ice, which occurseach one�and one heft seconds,

10 glasses of water and empty them in the kitchen sink.This will insure complete filling of the rsserv(fir with fresh water. Do not discard water into the grille at the bottom of the fountain. This is a spill ares, not a drain. Normal spills will be evaporated in the recessed ares below the spill shelf grille. Excessive spills should be removed wi_ an absorbent sponge or cloth. The spill area should be cleaned occasionally. FOUNTAIN LIGHT

-,,---

The push button light switch is located behind the panel st the top and on the left side of yourfountain. For replacement,use a 120V, 7 watt benx Disconnect the pewer cord before After installation, it may take 2 to 3 days to fill the ice storage bin with cubes. _'--2. Check to see if the tray is level. 3. If the tray is not level, the ice maker is in the dumping cycle. Wait until the tray is level before proceeding� (AbOut 8 rainutes.) 4. If the tray is level move the wire arm to the "OFF" position. (1) _up_Sr'c "_L'_-replacingfountain light bulb

REMOVING =,REPLACING T.E front of the ice storage bin and pull ICE DISPENSER SIN Lift the
it straight out. Wash the bin occasionally in mild soap and lukewarm water. To replace the bin, pushltellthewayback untilthe bottom of the bin is behind the raised edge at the front of the shelf its rests upon. Make sure the tabs, atthebackofthebin, thetturn the spiral auger are positioned between the prongs from the auger motor. ICE DISPENSER NOT WORKING

REPLACING LIGHT BULB
DISCONNECT THE POWER CORD BEFORE REPLACING LIGHT BULB

Fresh Food Colnp6,bzV4nt
ALWAYS USE A 40 WATT, STANDARD BASLE, APPLIANCE TYPE BULB WHEN REPLACING A LIGHT.

If your ice dispenser is not used often, ice clumps can form in the storage bin and cauee a malfunction of the ice disperser. If this happens, remove the storage bin end discard all ice cubes that are Stucktogether. Remove any clumpa that are stuck in the chute at the front of the bin, theice chute in the freezer door and those blocking the disper_er opening. Never add lie ¢ubee _ mtoth_ ImMrce to yore' foe di_pssmm, _ _ could _ Im Ice Jam in your _ Fmnl_. If this happens, remove the storage bin and discard all ice cubes. Remove any clumps that are stuck in the chute at the front of the bin, the ice chute in the freezer door and those blocking the dispenser open-

GOING VACATION

ON ?

If you will be gone for a month or less. leave the control knob at its usual setting. During longer absences, (a) remove all food, (b) disconnectfrom electrical eeffet, (c) clean the refrigerator thoroughly, including defrost pan, (d) leave doors open to prevent odor formation.

I"w_

ARM

5. Check the cube pockets to determine whether the water is frozen, if not, be sure you keep the tray level so as not to spill the water while removing the tray. 6. Remove the plastic retaining clip by sliding in the direction indicated on the clip. (2) 7. Pull the tray streightout off of the shaft, (3) 8. To reinstallthe tray, reverss the removal procedure. 9. Reinstallthe panel that goes in front of the ice maker by reversing the removal procedure,

ing.
OPt.RATING YOUR WATER DIL°ENSER To dispense water, press a container against the padded lever at the left side of the fountain, To stop the water flow, release pressure. To mlnimi=e splashing, hok:l the container as high as possible. When you first operate your disperw.eror af_lf reconnecting water to your refrigerator, air will escape from the dispenser for a few minutes before water begins to flow, Dravf

CLEANING
REMOVE ALL CONTENTE AND DISCONNECT THE POWER CORD BEFORE CLEANING Your reffigerator can be easily roiled out for cleaning. Simply turn the levelm feet COUNTERCLOCKWISE until they tom f_e. Theft pull the cabinet might out. We recommend that you tom the w&_,- supply off before moving the (_ll0inelt. Continued On Back