I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Text excerpt from page 5 (click to view)
Operating sequence
1. Check the filters
Ensure they are clean and properly positioned See "Maintenance and cleaning" section.
9. At the end of the washing programme
At the end of the programme the dishwasher will automatically stop. The �Mains On� indicator light remains on until the On/Off push button is depressed.
2. Check that there is rinse aid and salt
See "Before Use" section.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off push button. Wait 15/20 minutes before opening the dishwashers�s door; in this way you will avoid burning yourself when removing the dishes and avoid also the damage of the nearby furniture caused by the escape of steam. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
3. Load the dishes
Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it. Slide the baskets back into the machine.
4. Ensure that the spray arms can rotate freely. 5. Measure out detergent
Add the required amount of detergent into the dispenser according to the "Washing programmes" chart. Close the detergent dispenser lid.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.
Important! Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.
6. Close the dishwasher door
7. Set the programme
Turn the programme selector dial clockwise until the programme marker on the knob corresponds with the number of the programme you wish to select.
8. Start the programme
Depress the On/Off push button. The "Mains On" indicator light will come on and the machine will start. If you wish to interrupt the washing programme at any time press this button again.
