Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Text excerpt from page 1 (click to view)
2. OPERATION CHART: MODULE QW-1395
TO SET TIME
1) Pull the crown out when the second hand is at 12 o�clock position and the second hand stops. 2) Turn the hands clockwise and put the watch four or five minutes forward. Then back them out. 3) In accordance with a time signal, push the crown in.
s For watch with the elapsed time bezel Rotate the elapsed time bezel to align the mark with the minute hand. After certain amount of time elapsed, read the graduation on the elapsed time bezel which the minute hand points to. The elapsed time is indicated. Some water resistant models are equipped with a screw lock crown. With such models, you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out. Do not pull too forcibly on such crowns. Also note that such watches are not water resistant while their crowns are loosened. Be sure to screw the crowns back in as far as they will go after making any setting.
L (Light button)
1 02 5 0
Elapsed time bezel
ABOUT THE BACKLIGHT
� Hold down L to illuminate the face of the watch. � The backlight of this watch employs an electroluminescent (EL) light, which loses its illuminating power after very long term use. � Frequent use of the backlight shortens the battery life.
