|
|
|
Who's Online
There currently are 5396 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
 ;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
;
Thank you, this is a rare document. Few others have it, but they charge way more for a download.
Great deal (even if you have to wait a few hours to get it).
BJC-5000
Part 5: Maintenance
7.Machine Temperature Error
<Cause> The thermistor is abnormal. <Suspected Parts> Thermistor <Corrective Action> Replace the logic board.
8.Waste Ink-Full Warning/Error
<Corrective Action>
Visual check of the waste ink absorber
<Cause> The waste ink absorbers� estimated waste ink amount
has reached 95% (Warning) or 100% (Error). <Suspected Parts> Waste ink absorbers, logic board
� Check to see how much ink the waste ink absorber has absorbed. (Check the rate of ink penetration for the entire waste ink absorber as a guideline to determine the waste ink counter setting value.) No 1. Reset the waste ink amount in the EEPROM. 2. Replace the logic board. 0% (clear), 25%, 50% or 75% (See Part 3 �3.4 Service Mode.)
Waste ink absorbed is 75 % or more of the limit ? Yes
Replace the waste ink absorber. END
� Clear the total of the waste ink amount saved in the EEPROM.
5-21
|
|
|
> |
|
