|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very fast and perfect delivery. Clear and well scanned. A lot of work professionally realized.
Again thak you a lot
 ;
This manual is accurate and of high quality. It is only volume 2 of the service manual. This is schematic, parts lists, and exploded mechanical drawings. The theory of operation and the diss-assembly instructions are in volume 1. The unit can be tricky to dis-assemble portions of so the volume 1 manual can be important. The product description of the manual is accurate but it does not say anything about volume 1 and the image of the front page does clearly say Volume 2.
;
Wellll again thank you very much fast and effective. Clear and well done for such an old TV!!!!
;
It has all the information you will need to fix it. The main circuit diagram is only A4 but being a PDF, you can print it to any size - I did it on two sheets of A3 and it didnt lose any detail - just made it readable when pinned up above the bench. I've found the fault, just need to buy some obscure bits to get it going again!
I cant fault the process, I paid for the manual in the morning and it was ready to download by lunch time.
;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
5-5. AT Head Cleaner Replacement
Removal 1. Remove the CL Arm Assembly (1) Turn the M gear of the gear box assembly manually and move the CL arm assembly to the position shown in the figure. n Move the CL arm assembly to the front of the SE-341 board. If not, the CL arm assembly cannot be removed because the stop washer is hidden by other parts. (2) Remove the stop washer at the top of the CL arm assembly. (3) Remove the CL arm assembly from the threading ring. n Do not remove the spring at the bottom of the CL arm from the shaft.
Hole M gear Gear box assembly CL arm assenbly
SE-341 board
CL arm assembly
Stop washer
Installation 2. Attach the CL Arm Assembly (1) Pass a new CL arm assembly through the shaft while hooking the spring as shown in the figure. n Insert the short-end of the spring into the groove of the threading ring and the long-end spring into the hole of the CL arm assembly. (2) Fix the CL arm assembly by new stop washer.
Remove the CL Arm Assembly
SE-341 board Threading ring Shaft Spring
Groove
Stop washer (2.3) : 3-669-596-00
DNW-A100/A50/A45 DNW-A100P/A50P/A45P
5-33
|
|
|
> |
|
