|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, thank you, sony kp46s3 service manual perfectly, i am very happy.
;
Complete original Service Manual in good (scan) quality!
;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
2-1-5. How to Attach the Hard Disk Drive Unit (BKSH-102G)
Notes: 1) The six hard disk drive (HDD) units are installed in the media unit (VSH-1000) when the media unit (VSH-1000) is connected to the media control unit (VSR-1000) and used. 2) A maximum of six HDD units can be installed in a media unit when a media unit (VSH-1000) is connected to the MPEG-2 encoding unit (VST-1000/1000P) and used. 3) Never subject the HDD units to severe shocks. 1. Confirm that the POWER switch of HDD unit is in the OFF position. 2. Remove the four screws and remove the front panel. 3. Remove the two screws and remove the blank panels. Note: Remove the blank panels corresponding to the HDD units to install.
Screws PSW 3�8
Screws B 3�6
Front panel
Screws B 3�6
4. Align the rails of the HDD unit with the guide rails of the unit. 5. Move the top eject lever of the HDD unit in a level. Insert the HDD unit until the eject lever contact the unit with the bottom eject lever opened in the direction shown by arrow 1. 6. Insert the eject levers in the direction of arrow 2 and lock them. (The HDD unit is inserted to its end.)
(Lever in a level)
Guide rail
Rail
Guide rail 2 HDD Unit Power switch 1 Eject lever
Media unit
2-4
|
|
|
> |
|
