|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0409030000.html
4.9.3 Adjustment Procedure
TOP PREVIOUS NEXT 1. Input an NTSC monoscope pattern signal and check that the picture locks horizontally. 2. Set the SCAN switch to over-scanning mode (original size). 3. Set the monitor to the FACTORY mode and select DISPLAY REF from the menu. 4. Adjust H POSI and V POSI on the DISPLAY REF menu to position the center of the picture at the center on the front of the picture tube. 5. Adjust H SIZE and V SIZE on the DISPLAY REF menu to obtain a horizontal scale of 2.5±0.3 and a vertical scale of 2.0±0.3 as a screen size. 6. Set the SCAN switch to under-scanning mode and check that the picture is fully displayed. 7. Set the ASPECT switch to the 16:9 mode and check that the vertical screen size is 175 mm±8 mm. 8. Set the SCAN switch to over-scanning mode (original size) and change the input signal to a PAL Philips pattern signal. 9. Set the ASPECT switch to the 4:3 mode and check that the center of the picture is positioned at the center on the front of the picture tube. 10. Set the SCAN switch to under-scanning mode and check that the picture is fully displayed. 11. Set the ASPECT/ switch to the 16:9 mode and check that the vertical screen size is 175 mm±8 mm. �@ TOP PREVIOUS NEXT
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0409030000.html [2006-02-04 08:28:39]
|
|
|
> |
|
