SHARP CDPC3500
Owner's Manual

(Continued)
Installation of the rear speakers:
Example: When installed on the wall Wall 23" - 35" (60 - 90 cm) Example: When installed vertically If possible, mount the rear speakers on the wall. lnstall them 23" - 35" (60 - 90 cm) above the height of your ears when seated, if possible.

s To mount the rear speakers on the wall
1/8" (3.2 mm) 3/16" (5 mm) The design of the rear speakers allows them to be hung on the wall. Be sure to use the type and size screw that is shown to the left. Drive one screw into the wall for each speaker as shown in the illustration. q Make sure that both the screw and the wall can support a load of 45 lbs. (20 kg). q Drive the screws, so there is about a 3/16" (4 mm) space between the wall and the head of the screw. Min. 11/16" (18 mm) Wall surface Wall mounting screw

Min. 7/8" (22 mm) 3/8" (9 mm) 3/16" (4 mm)

1

1

2

Mount the rear speaker on the wall so that the screw head is inserted into the slot on the rear speaker.

2
Wall surface

Note: When the rear speakers are installed vertically, the speaker badge will be upside down. In this case, you can adjust the badge to face the proper direction. Just turn it by hand. Badge

(Front speakers only)

s Removing the speaker grilles

1 2

Remove the lower part of the speaker grille first.

Remove the upper part of the speaker grille. q The speaker grilles on the center and rear speakers are not removable. Caution: When the speaker grilles are removed, the speaker diaphragms are exposed. Make sure nothing comes into contact with the speaker diaphragms.

s Mounting the speaker grilles
Fit the four posts on the speaker grille into the mounting holes and push them lightly with the palm of your hand to secure.

AC 120 V, 60 Hz

s Connecting the AC power cord
q After connecting the speakers, plug the AC power cord into a convenient AC outlet. q Unplug the AC power cord from the AC outlet if the unit will not be in used for a prolonged period of time.

To an AC outlet

8