This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
Fantastic quality and impressive delivery time. Based on this manual, I recommend this service without hesitation! Five Stars for certain.
Text excerpt from page 30 (click to view)
4
Adjusting the volume of the bass and treble
You can adjust the volume of the bass and treble to best fit the acoustic characteristics inside your car.
Rotate the dial to select the turn-over frequency. The turn-over frequencies change as follows:
Bass:
198 Hz n 250 Hz n 314 Hz* n 396 Hz
Treble:
2.0 kHz n 3.1 kHz* n 4.0 kHz n 5.0 kHz
1 2 3
Press (SOURCE) to select a source (tuner, CD or MD). Press (SOUND) repeatedly until �BAS� or �TRE� appears. Rotate the dial to adjust the volume. After three seconds, the display goes back to normal playback mode.
* Factory-set frequency
5
Press (SOUND) for two seconds. The display goes back to normal playback mode.
Adjusting the turn-over frequency
You can adjust the bass and treble turn-over frequencies.
Listening to each program source in its registered surround menu
� Last Sound Memory (LSM)
You can listen to the same source always in the same surround menu even after changing the program source or turning the unit on and off again.
EN
Turn-over frequency
Frequency (Hz)
1 2 3
Press (SOURCE) to select a source (tuner, CD or MD). Press (SOUND) for two seconds. Press (SOUND) repeatedly until �BAS� or �TRE� appears.
Bass adjusting mode
Changing the line output level
You can change the line output level if you hear distortion or other noise.
1 2
Press (SHIFT), then press (3) (SET UP) until �L.out� appears. Press (5) (n) to select the desired setting (�10 dB or �16 dB). Press (SHIFT).
