WHIRLPOOL CER3735ACZ
Owner's Manual

3. Press the CLEAN pad. � �CLEAN� will flash. 4. Press the � or � pad. � �CL-M� (Medium Soil, 3 hours) is displayed. 5. Press the � or � pad to scroll through the self-cleaning settings. CL-H� (Heavy Soil, 4 hours) CL-M� (Medium soil, 3 hours) CL-L� (Light Soil, 2 hours) Choosing the soil level of the oven automatically programs the self-cleaning time. 6. After four seconds, CLEAN, DELAY and LOCK will appear in the display to show that the oven is set for a delayed clean operation. The delay time is displayed.

Sounds
As the oven heats, you may hear sounds of metal parts expanding and contracting. This is normal and will not damage the oven.

After Self-Cleaning
About one hour after the end of the self-clean cycle, LOCK will turn off. The door can then be opened. Move door lock lever to the left to unlock. Some soil may leave a light gray, powdery ash. Remove it with a damp cloth. If soil remains after wiping, that means the clean cycle was not long enough. The soil will be removed during the next clean cycle. If oven racks were left in the oven and do not slide smoothly after a clean cycle, wipe racks and rack supports with a small amount of vegetable oil to make them easier to move. Fine lines may appear in the porcelain because it went through heating and cooling. This is normal and will not affect performance.

If the oven has already been set for a clean cycle and you wish to set a delay:
1. Press the DELAY pad. � �DELAY� flashes. � 00:00 will appear in the display. 2. Press the � or � pad to set the amount of time you want to delay the cycle. After four seconds, CLEAN, DELAY and LOCK will appear in the display to show that the oven is set for a delayed clean operation. The delay time is displayed.

A white discoloration may appear after cleaning if acidic or sugary foods were not wiped up before the self-clean cycle. This discoloration is normal and will not affect performance.

Notes:
� If the oven door is left open, �DOOR� will flash in the display and a signal will beep until the door is closed and the CLEAN pad is pressed again. � If more than five seconds elapse between pressing the CLEAN pad and the � or � pad, the program will automatically return to the previous display. � The oven door will be damaged if the oven door is forced to open when �LOCK� is still displayed.

When the Self-Clean cycle starts:
� �DELAY� will turn off. � The clean time will appear in the display.

To cancel the Self-Clean cycle:
Press the CANCEL pad.

Cleaning Procedures
CAUTION
� Be sure appliance is off and all parts are cool before handling or cleaning. This is to avoid damage and possible burns. � To prevent staining or discoloration, clean appliance after each use. � If a part is removed, be sure it is correctly replaced. Backguard and Cooktop � Porcelain Enamel Porcelain enamel is glass fused on metal and may crack or chip with misuse. It is acid resistant, not acid proof. All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth. � When cool, wash with soapy water, rinse and dry. � Never wipe off a warm or hot surface with a damp cloth. This may cause cracking or chipping.

� All words disappear from the display. � All functions are canceled. � The time of day appears in the display.

During the Self-Clean Cycle
When LOCK shows in the display, the door cannot be opened. To prevent damage to the door, do not force the door open when LOCK is displayed.

Smoke and Smells
You may see some smoke and smell an odor the first few times the oven is cleaned. This is normal and will lessen in time. Smoke may also occur if the oven is heavily soiled or if a broiler pan was left in the oven.

5