|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
 ;
again you did a very good job. It was fast too. Photocopy are really readable and clear
 ;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
Code No.
Setting (The default is Highlighted ). <Delete Account> Delete an account (access number) which has previously been stored. <Procedure> 1. Enter �3� from the 10-Key Pad. (Display: A-3) 2. Press the Start key. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-3� and �blank.� 3. Press the Zoom key to display the account to be deleted. 4. Press the Start key to delete the account. <Change Account> Change an access number which has previously been programmed. <Procedure> 1. Enter �4� from the 10-Key Pad. (Display: A-4) 2. Press the Start key. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-4� and �blank.� 3. Press the Zoom key to display the access number to be changed. 4. Press the Start key to validate the access number displayed. 5. Enter a new access number from the 10-Key Pad. 6. Press the Start key to validate the new access number just entered. � If the new access number just entered already exists, �Err� appears on the Display and then the Display blanks out. In this case, perform steps 5 and 6 again. <Total Counter Display by Account> Display the count of the Total Counter for each account. <Procedure> 1. Enter �5� from the 10-Key Pad. (Display: A-5) 2. Press the Start key. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-5� and �blank.� 3. Press the Zoom key to display the access number. 4. Press the Start key to validate the access number displayed. 5. Press the Start key. This will allow the Total Counter value to be displayed. E.g.: �123� and �456� alternate if the count is 123,456. 6. Press the Clear key to clear the count. If the count is mistakenly cleared, press the Interrupt key, which will restore the count just cleared. <Total Counter Clear for All Accounts> Clear the Total Counter counts for all accounts. <Procedure> 1. Enter �6� from the 10-Key Pad. (Display: A-6) 2. Press the Start key. Then, �CLr� appears on the Display. 3. Press the Start key again to clear all counts.
A-3
A-4
A-5
A-6
S-12
|
|
 |
> |
|