|
|
|
Who's Online
There currently are 5872 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
OPERATION
Open the door. Load clothes loosely into the drum. Load sheets first starting with one corner. Close the door. Dry your hands. Plug in the machine. Select either dry or extra dry, using the button. Press the start button. The drum will rotate in an anticlockwise direction, with all the drying status lights (if fitted) illuminating in sequence i.e. Red/Amber/Green/Green. If the machine has no load in the drum it will switch off automatically after approximately 40 seconds The drum will now begin to rotate and will stop automatically when your clothes are dry. The drum will stop and turn in the other direction for a short while every few minutes. There is an automatic 12 minute cool down period at the end of every cycle, during which the heater is switched off. This helps to minimise creasing. The dryer on neon will remain lit until the end of the cycle. At the end of the cycle the neon will flash to indicate that the dryer is in anti-crease. The drum will rotate periodically until you open the door or disconnect from the mains to stop it. This helps to minimise creasing. If the door is opened during a cycle the dryer will stop. If a load is checked mid cycle restart the appliance by, closing the door and pressing the start button. When drying large items such as sheets, we suggest you periodically stop the dryer to redistribute the load. NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM.
AFTER REMOVING THE DRIED CLOTHES
ALWAYS CLEAN THE FILTER. Failure to do so could cause the safety cut-out to operate.
;;;;;;; � Pull the filter upwards and away from ;;;;;;; the appliance. ;;;;;;; ;;;;;;; ;;;;;;; ;;;;;; � Remove any threads or fluff by hand or ;;;;;;;;;; ;;;;;;; ;;;;;; ;;;;;;;;;; ;;;;;;;;;; ;;;;;;;;;; with a soft brush. ;;;;;;;;;;
� � Slide the filter back. Wash the filter occasionally in detergent solution using a soft brush to remove small particles.
ALWAYS EMPTY THE WATER BOTTLE
�
Open the door, pull out and empty the bottle. Replace the bottle ensuring that it is pushed all the way in - if it is not, the dryer will not operate. If the dryer is connected to a drain there is no need to empty the bottle but it must be correctly fitted to the machine.
�
�
ADDITIONAL INFORMATION
ANY PROBLEMS
If the clothes are not dry after normal drying time: � � Check that the lint filter has been cleaned. A blocked filter will restrict the airflow. Check that the machine has the correct weight load in the drum, this machine will stop after approximately 40 seconds if the drum is empty. Check that the door striker is in place if the machine is a large door opening model. Check that the condenser unit and associated duct work are clean. If blocked these will restrict the airflow. Check that your dryer is heating - below the door to the left side, should feel warm to the touch after the first 10-15 minutes of its programme. Failure to heat may indicate the safety cut-out has operated. To reset, simply press the red button at the rear of the machine. If it has operated then a sharp �click� will be heard. This cut-out only operates if the airflow is severely restricted so make sure the filter is clean and that all other restrictions are removed before re-starting. If the cut-out continues to operate after checking the above points, you should contact your service agent. � Check that you have selected the correct dryness setting. For electrical ratings see plate on back of dryer. For Model No. see serial plate inside door (needed when requesting service). Room temperature range 5�C to 30�C. Your washing machine should have a spin speed of not less than 800rpm. The �dry� setting was used to rate the energy efficiency of this appliance.
OPTIONAL EXTRAS
Drain Hose Kit To enable your dryer to be connected to a drain to remove the need to empty the water bottle. The above item can be purchased as an accessory for your tumble dryer from your supplier.
� � �
TECHNICAL DATA OVERALL DIMENSIONS:
Height: 85 cm Width: 59.5 cm Depth: 58 cm
MAXIMUM DRY WEIGHT LOADS:
Cotton 6kg (for minimum creasing 2kg) Delicates 2kg
If your machine does not work check the following before calling a service engineer: � � � � Check that there is a supply of electricity. Check that the door has been properly closed and the machine is switched on. Check that the water bottle has been withdrawn from, and replaced into the machine. Check the plug internal connections.
|
|
|
> |
|
