Rear Panel
The rear panel of the Control X has one 5 pin DIN jack used to connect the Control X to the GENETX� processor with the supplied 5 pin DIN cable.
Connections
Connecting the Control X to your GENETX� Processor is very easy. Just follow these simple steps when connecting the Control X: 1. Begin with the power to your GENETX� Processor turned off. 2. Using the supplied 5-pin DIN cable, connect from the output jack located on the rear panel of the Control X to the MIDI/Foot Controller jack on the back of your GENETX� Processor. 3. Make sure the MIDI/Foot Controller switch on the GENETX� processor is set to the Foot Controller option and NOT to MIDI. 4. Power up the GENETX� Processor. When the display returns to the current program number, the Control X is ready to use. If the Display reads Pf, or your Expression Pedal fails to function, see the calibration procedure in this manual.
Bank Up/Tuner Foot Switch
This foot switch will advance through the user banks of presets. Each successive press of the Bank Up Switch will advance to the next bank of presets. Once a new bank has been selected, the 3 available preset numbers will be shown in the Display and the 1, 2, and 3 switches will flash prompting you to select a preset within that bank. If no preset selection is made within 5 seconds of selecting a new bank, the GENETX� processor will revert back to the previously selected bank and preset.
Tuner
To activate the tuner, press and hold the Bank Up switch for 2 seconds.The display will briefly read tu followed by the tuner reference, indicating that the GENETX� processor is in tuner mode. Begin by playing a note on your instrument. The numeric display will show the note being played.The 7 LEDs beneath the display will provide an indication as to whether the note is flat, sharp, or in tune.When the single green LED in the center is lit, the note is in tune. LEDs to the left indicate your note is flat and LEDs to the right indicate your note is sharp. Exit tuner mode by pressing any footswitch.
