I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Text excerpt from page 14 (click to view)
5.3. Inspection of the P-Board - As the P-Board can not be inspected from the pattern side, refer to the pattern side/parts side of the circuit diagram and perform the inspection by bringing the tester into contact with the jumper wires and parts. 5.4. Parts exchange for the P-Board 1. When parts are to be exchanged, first remove the screws (3 screws : (1) to (3) Refer to Fig. 4) fixing the print holder. 2. Next, remove the screws (3 screws: (4) to (6) :Refer to Fig.4) 3. Remove the P-Board from the D-Board (3 connectors: P1 to P3: Refer to Fig. 4), and then exchange the parts.
14
