|
|
|
Who's Online
There currently are 5917 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
IC DESCRIPTION -1/1 (µPD178006AGC-555-3B9, µPD178018AGC) -2/2
Pin No. 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 Pin Name SUB M CONT 2 MODE PL REEL STAND-BY F/R HEAD MS IN LED MI-1 MI-2 MI-3 MO-1 MO-2 MO-3 MO-4 BS CONT NR CONT MTL CONT BEEP RMT IN E-VOL CE E-VOL DO E-VOL CLO DSSA RDS DI DFP IN FLAP IN RDS CLI EJECT IN ACC IN RE1 IN RE2 IN PACK IN REG CPU GND X-OUT X-IN REG OSC VDD RESET O O O O I O O O O I I I I I I I I I � � � I � � I MS/BL switching output. Open when not used Dolby B NR on/off output. Open when not used Metal tape on/off output. Open when not used Beep output (3 kHz, 50 ms) Remote control input. Pulled up when not used CE output to electronic VR (LC75374E) Data output to electronic VR (LC75374E) Clock output to electronic VR (LC75374E) Outputs "H" only when DSSA L/R are operating. RDS data inputPulled down when not used. Detects whether DFP (front panel) is provided or not. Detects whether flap DFP is open or closed. RDS clock inputPulled down when not used NC (pulled down) ACC (accessory power supply) on/off input Rotary encoder input 1. Rotary encoder input 2. Tape insertion status detection input CPU power regulator Ground System clock oscillator System clock oscillator Regulator for oscillator circuit Power supply System reset input O Diode matrix output for initial setting I Diode matrix input for initial setting I/O O I I I O I O Sub motor control output-2. Mode pulse input for tape mechanism. Reel pulse input for tape mechanism. Mechanism Stand-by input Head FWD/REV select output. MS signal input (no music: "H", with music: "L"). Pulled when not used Security LED flashing output ("H": 120-130 ns, 1 cycle: 3 s) Description
-16-
|
|
|
> |
|
