KORG D1600
Owner's Manual

The �Attack� and �Release� parameters specify attack time and release time of delay level control.

Phase (LFO Phase [degree]) ... �180...+180 Sets the LFO phase difference between the left and right *Speed (LFO Frequency [Hz])..0.02...20.0Hz Sets the LFO speed *Depth (Depth) ................................... 0...100 Sets the depth of LFO modulation Fdback (Feedback)................... �100...+100 Sets the feedback amount HiDamp (High Damp [%])................. 0...100 Sets the feedback damping amount in the high range Mix (Wet/Dry) ................. �Wet...�1:99, Dry, Sets the balance between the effect 1:99...Wet and dry sounds

13: DL6: St.Auto Panning Delay
(Stereo Auto Panning Delay)
This stereo delay effect pans the delay sound left and right using the LFO.
LTime (L Delay Time [msec])....... 0...680ms Sets the delay time for the left channel LFback (L Feedback)................ �100...+100 Sets the feedback amount for the left channel RTime (R Delay Time [msec]) ..... 0...680ms Sets the delay time for the right channel RFback (R Feedback) .............. �100...+100 Sets the feedback amount for the right channel HiDamp (High Damp [%])................. 0...100 Sets the damping amount in the high range LoDamp (Low Damp [%]) ................. 0...100 Sets the damping amount in the low range LFO (LFO Waveform) .................... TRI, SIN Selects LFO Waveform Shape (LFO Shape) ................. �100...+100 Determines how much the LFO waveform is changed Phase (LFO Phase [degree]) ... �180...+180 Sets the LFO phase difference between the left and right *Speed(Panning Frequency [Hz]) ................. Sets the panning speed 0.02...20.0Hz *Depth (Panning Depth) ..................... 0...100 Sets the panning width Mix (Wet/Dry) ..............Dry, 1:99...99:1, Wet Sets the balance between the effect and dry sounds

: LFO Shape Changing the LFO waveform shape controls the peak sweep of �anging effects. : Feedback, : Wet/Dry The peak shape of the positive and negative �Feedback� value is different. The harmonics will be emphasized when the effect sound is mixed with the dry sound if you set a positive value for both �Feedback� and �Wet/Dry�, and if you set a negative value for both �Feedback� and �Wet/Dry�. : High Damp [%] This parameter sets the amount of damping of the feedback in the high range. Increasing the value will cut high-range harmonics.

16: MO3: St.Phaser (Stereo Phaser)
This effect creates a swell by shifting the phase. It is very effective on electric piano sounds. This is a stereo effect, and you can control the spaciousness of the sound by offsetting the phase of the left and right LFOs from each other.
LFO (LFO Waveform) .................... TRI, SIN Selects LFO Waveform Shape (LFO Shape) ................. �100...+100 Determines how much the LFO waveform is changed Phase (LFO Phase [degree]) ... �180...+180 Sets the LFO phase difference between the left and right *Speed (LFO Frequency [Hz])..0.02...20.0Hz Sets the LFO speed Manual (Manual)............................... 0...100 Sets the frequency to which the effect is applied

Modulation MO1� MO7
Category: Modulation-type effects
14: MO1: St.Chorus (Stereo Chorus)
This effect adds thickness and warmth to the sound by modulating the delay time of the input signal. A two-band equalizer can be used to adjust the tone of the effect sound. You can control the spaciousness of the sound by offsetting the phase of the left and right LFOs from each other.
LFO (LFO Waveform) .................... TRI, SIN Selects LFO Waveform Phase (LFO Phase [degree]) ... �180...+180 Sets the LFO phase difference between the left and right *Speed (LFO Frequency [Hz])..0.02...20.0Hz Sets the LFO speed LDly (L Pre Delay [msec])........ 0.0...50.0ms Sets the delay time for the left channel RDly (R Pre Delay [msec]) ...... 0.0...50.0ms Sets the delay time for the right channel *Depth (Depth) ................................... 0...100 Sets the depth of LFO modulation EQTrim (EQ Trim) ............................. 0...100 Sets the EQ input level LEQG (Pre LEQ Gain [dB]) .... �15.0...+15.0 Sets the gain of Low EQ HEQG (Pre HEQ Gain [dB]) ... �15.0...+15.0 Sets the gain of High EQ Mix (Wet/Dry) ..................�Wet...�1:99, Dry, Sets the balance between the effect 1:99...Wet and dry sounds

*Depth (Depth) ................................... 0...100 Sets the depth of LFO modulation Reso (Resonance) ................... �100...+100 Sets the resonance amount HiDamp (High Damp [%])................. 0...100 Sets the resonance damping amount in the high range Mix (Wet/Dry) ................. �Wet...�1:99, Dry, Sets the balance between the effect 1:99...Wet and dry sounds

: Resonance, : Wet/Dry The peak shape of the positive and negative Feedback value is different. The harmonics will be emphasized when the effect sound is mixed with the dry sound, if you set a positive value for both �Resonance� and �Wet/Dry�, and if you set a negative value for both �Resonance� and �Wet/Dry�. : High Damp [%] This parameter sets the amount of damping of the resonance in the high range. Increasing the value will cut high-range harmonics.

17: MO4: St.Vibrato (Stereo Vibrato)
This effect causes the pitch of the input signal to shimmer. You can use an expression pedal etc. to gradually increase or decrease the shimmering speed.
LFO (LFO Waveform) .................... TRI, SIN Selects LFO Waveform Shape (LFO Shape) ................. �100...+100 Determines how much the LFO waveform is changed *Speed (LFO Frequency [Hz])..0.02...20.0Hz Sets the LFO speed *Depth (Depth) ................................... 0...100 Sets the depth of LFO modulation Mix (Wet/Dry) ..............Dry, 1:99...99:1, Wet Sets the balance between the effect and dry sounds

: L Pre Delay [msec], : R Pre Delay [msec] Setting the left and right delay time individually allows you to control the stereo image.

15: MO2: St.Flanger (Stereo Flanger)
This effect gives a signi�cant swell and movement of pitch to the sound. It is more effective when applied to a sound with a lot of harmonics. This is a stereo �anger. You can add spread to the sound by offsetting the phase of the left and right LFOs from each other.
Time (Delay Time [msec]) ....... 0.0...50.0ms Sets the delay time from the original sound LFO (LFO Waveform) .................... TRI, SIN Selects LFO Waveform Shape (LFO Shape) ................. �100...+100 Determines how much the LFO waveform is changed

115

Ins(2in2outx2)/Mst/Final Effect