BANG&OLUFSEN D6_PLASMA
Service Manual

PDP pixel test, English

1.9

PDP pixel test
The PDP pixel test checks the status of the PDP, with regard to the number of defective pixels The test is used: - before transporting the product or the PDP to a workshop - before and after service on the PDP When the PDP is fitted an aluminium front frame, point the NN remote control at the hole in the left-hand front bottom side of the PDP. See �6. By means of a thin tool press in the holes FD the FE and then FF on the NN remote control. For other operations point the NN remote in the same way. Refer to illustrations for: - Placement of black self-adhesive tape on the PDP. - Placement of buttons on NN remote control. Remove the black self-adhesive tape on the PDP. See �4. Switch on the PDP. Enter service mode, CAT Panel menu. Press and hold button �B� and at the same time press button �C� 3 times within 1 second. See �4 and �5. Select Aging. Place the cursor on IIC Mode and press �OK�. Select �Aging�, use the up/down arrow buttons to step through the pictures on the on-screen-display. Press �OK� to activate the internal test pictures. Press �OK� to switch between the different test pictures. PDP pixel test. Use the �GREEN�, �RED� and �BLUE� test picture for checking the pixels. Exit service mode. Press �R� twice to return to CAT Panel menu. Press �C� to exit the service mode.

�4

�5

�6

+

VOL

_+
R

LED

B

C

OK

R
FD FE FF