|
|
|
Who's Online
There currently are 6028 guests and
15 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
2-1-3. How to Set the Optical Sensor Disc 1) Fit a lug on the sensor side of optical sensor disc in the hole of the drive.
2-1-4. Precautions on Adjustment 1. Adjustment data The adjustment data for the drive block are recorded to the IC4403 on the MD-114 board. These data cannot be read or written from the adjustment remote commander or SeusCam, unlike the camera and LCD adjustment data. Accordingly, be sure to adjust all items of the drive adjustment when the following parts were replaced: � Drive block � Mounted MD-114 board 2. Order of adjustment Adjust the drive block in the following order: 1) POWER Adjustment 2) DVD-R Adjustment 3) DVD-RW Adjustment 4) DVD+RW Adjustment 3. Precaution on the laser diode
Fit a lug in the hole of drive.
Fig. 6-2-3
2) Push in the optical sensor disc until it clicks in the same manner as when setting a disc.
In the POWER Adjustment, operate the drive with the disc cover left open. During the adjustment, be sure to observe the following precautions: 1) Set the optical sensor disc correctly. 2) Keep the distance of more than 30 cm apart from the camcoder. 3) Work on the LCD screen side of the camcoder (opposite side of the drive). Note: Laser light of the equipment is focused by the object lens in the optical pick-up so that the light focuses on the reflection surface of the disc Therefore, be sure to keep your eyes more then 30 cm apart from the object lens when you check the emission of laser diode
Pickup Lens (Laser Diode)
Fig. 6-2-4
Fig. 6-2-5
DCR-DVD403/DVD403E/DVD803/DVD803E 6-46
|
|
|
> |
|
