The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
The manual for the Sansui P-L75 was not one of the more informative turntable manuals around but for $5 it was helpful enough.
Text excerpt from page 71 (click to view)
DCR-PC115/PC115E/PC120BT/PC120E
[Routing the Bluetooth BT cable] (PC120BT/PC120E)
BT cable
Rigid portion of the FJ-035 board
Flexible board of the FJ-035 board
A
BT cable
1 Pass the cable through the hole A of the Cabinet (R) section.
2 Draw the cable through clearance of the flexible board of the FJ-035 board and route it under the flexible board of the FJ-035 board. 3 Route the cable under the rigid portion of the FJ-035 board.
Route the cable through the clearance B, and then hook it on the clearance between the BT cable guide and lens device.
When removing the BT cable from the BT-003 board, be sure to hold the connector of the BT-003 cable and remove it.
BT cable Connector of BT cable
BT-003 board
BT cable guide
Lens device Attach the BT cable so that it stretches straight downward.
BT cable sheet
Lens rubber (R)
BT-003 board BT cable
BT cable
B
BT cable guide
6 Route the cable through the clearance B. 7 Insert it to the connector on the BT-003 board. 4 Insert it into the notch of the lens rubber (R). 5 Insert it into the notch of the BT cable sheet.
