This document is just what I was looking for, it´s very useful, it contains adjustment procedures for the final stage of the power amp and also
has a complete wiring diagram and description of the main semiconductors used in the design.
Text excerpt from page 56 (click to view)
1
2
3
4
7. GENERAL INFORMATION
7.1 DIAGNOSIS
A
7.1.1 DISASSEMBLY
- Removing the Case (not shown) 1. Remove the Case.
- Removing the CD Mechanism Module (Fig.1)
CD Mechanism Module
1
B
Remove the four screws.
Disconnect the connector and then remove the CD Mechanism Module.
1 1
- Removing the Grille Assy (Fig.1)
2
Remove the two screws and then remove the Grille Assy.
2
C
1 1
2
Grille Assy
- Removing the Tuner Amp Unit (Fig.2)
Fig.1
1
D
Remove the screw.
2
2 2
2 3 4
Remove the three screws.
Straighten the tabs at three locations indicated. Remove the screw and then remove the Tuner Amp Unit.
