|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This manual is immaculate in it's accuracy. Everything is written very clearly and easy to understand. Written by a professional who wants to convey a clear and easy to understand message!!
;
This Manual (as downloaded) is both informative and comprehensive and has proved to be extremely useful. thoroughly recommended.
;
everything is ok, thank you very much! Product is good, no problems with download!
;
Great site, I always find all the manuals I need and i can't find anywhere else. PDF for the Sony PCM 3348 is complete and scan is good quality. Thank you!
;
It was a complete manual as stated. Very good source for older product manuals. Thanks
Do not allow water to stand in the hottom of the cabinet. Lay one or more bath towels in the bottom of the freezer to soak up defrost water. When all frost has melted, remove the towels and the water, Wash interior surfaces and removable parts with warm water to which a little baking soda has been added. Rinse well and dry thoroughly. NO FROST MODELS No-Frost means that you will never have to defrost your Freezer. Frost is removed by air moving and collecting any moisture and depositing it on the cooling coil. The cooling coil periodically warms up just enough to melt the frost and it then flows down to the drain pan {located behind the base grille) where it is evaporated. REI_)T l'_IG_---_r_ j_xCING "I ]_UTJ]_
MOISTURE COLLECTS ON OUTSIDE SURFACE � Hot humid weather increases condensation. As humidity decreases, moisture wili disappear. BEFORE CALLING A SERVICEMAN, CHECK THE FOLLOWING LIST FOR POSSIBLE TROUBLES THAT YOU YOURSELF CAN REMEDY WITHOUT DIFFICULTY. NOISY OPERATIO N
HEAVY FROST IN FREEZER � Frequent door openings � Prolonged door openings � Hot, humid weather increases frost build-up FREEZER COMPARTMENT TOO WARM
� Cabinet not level � Weakfloor FREEZER WON'T RUN
� Temperature control turned to OFF � Line cord not plugged in � No power at electrical outlet . House fuea blown FREEZER RUNS TOO LONG � Prolonged door oponings � Control set too cold � Condenser needs cleaning � Poor air circulation around condenser FREEZER RUNS TOO FREQUENTLY
� Freezer control set tOOwarm � Prolonged door openings CABINET VIBRATES
� Cabinet not level � Weak floor CABINET WORKING LIGHT NOT
IT IS RECOMMENDED THAT YOU DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT BULB REPLACEMENT. Use a 25 watt, intermediate base, appliance type bulb when replacing the light.
� Bulb burned out � No powerat outlet
� Frequent running provides more stable temperatures Most power failures are corrected in an hour or two and will not affect your freezer temperatures. However, you should minimize the number of door openings while the power is off. During power failures of longer duretion, take steps to protect your frozen food by placing blocks of dry ice on top of the packages. If dry ice is not available, see if you can temporarily use a freezer in your Iocallocker plant. � Toomanydooropenings � Prolonged door openings FROZEN FOODS DRY OUT The model number, serial number and bill of material (BM) number of your model are listed on a serial plate, behind the decorative base grille at the lower front. Refer to all of these numbers in any correspondence with your dealer or distributor concerning your model.
IF
YOU
NEED
SERVICE
� Packages not wrapped or sealed propady
ODOR
IN CABINET
� Odor producing foods should be covered � Interior needscleenlng
Printed inU.S.A.
10-81
|
|
|
> |
|